PRODUCTS

LOCATION: KOHE > PRODUCTS & INNOVATION > Flying shears
FLYING SHEARS
COMPLETE SOLUTIONS FOR
■ Steel bars
■ Steel sections
Flying shears of different designs are used to cut the rolling stock in wire rod, bar and section mills as well as in continuous blooming mills.

■ Rotary shears
Rotary shears crop the head and tail ends of the rolled standees shears are also used for chopping. They are electrically driven and speed-controlled by frequency converters.

■ Lever shears
Lever shears are installed downstream of roughing trains of merchant bar, section and blooming mills for cropping. They make quasi right-angled cuts. The short knife lever enables short chopping lengths.

■ Dual shears
This combination of rotary and lever shear is used for cutting to cooling bed lengths. These shears operate at high speeds with relatively low power or at low speed with high power. A pneumatically controlled guide leads the rolled strand to the respective knife as required.

■ Four-crank shears
These shears are used for head and tail end cropping of rolling stock with crosses sections. Due to the favorable geometry of the cut, they guarantee high cutting security.

■ Pendulum-type shears
These shears are primarily used in continuous casting plants for cut- ting to cooling bed lengths. They are hydraulically or electromechanically driven.
A SUCCESSFUL PROJECT
video
If you need more information, please contact with us.